LogicAnalyzer records samples read from io periodically.
This is useful for digital bus signal check.
Only one LogicAnalyzer can be used per obniz Board.
How it works
LogicAnalyzer starts logging by a trigger.
The default trigger is "value change".
When it occurs, data will be recorded for a desired duration.
After that is done, LogicAnalyzer starts monitoring changes in io (= continue working).
One sample becomes one 1/0.
Sampling interval and duration can be configured.
For example, if interval is 1 ms and duration is 800ms, you will get 800 arrays of data.
The data will be in multiples of 8.
The default trigger is "value change", but it tends to be interrupted by some noise. Configure triggerValue/triggerValueSamples to filter it.
- triggerValue - desired start value. true/false
- triggerValueSamples - after how many samples will the recording start.
This trigger setting means "trigger when true/(or false) continues for more than X times after io change"
logicAnalyzer.start() starts the logic analyzer on a given io.
Interval means a period(second) to read io value.
data_long means for how long the logicAnalyzer will collect the data.
For example, if you want to collect the data after io0 changes every 2ms for 1sec long, set as below.
The trigger is an optional configuration.
Without this, logicAnalyzer recognizes any io level change as trigger and start. Trigger specifies the start position.
Value means start value, true/false. Samples means how much that value consists.
So, with the below sample code, you will only receive data that start with "0, 0, 0"
call logicAnalyzer.end() to end logicAnalyzer